[机]气缸盖

cylinder heads───气缸盖

cylinder seal───圆柱形印章；滚筒印章

cylinder seals───圆柱形印章；滚筒印章

cylinders seal───圆柱形印章；滚筒印章

cylinder saw───圆筒锯

cylindered───n.圆筒；汽缸；[数]柱面；圆柱状物

cylindered seal───圆柱形印章；滚筒印章

Place the engine cylinder head over the dowels.───将引擎汽缸头放在销上.

cylinder head is heavily finned for strength.───汽缸头附有许多突片以增加强度。

This is achieved by using cylinder head gasket.───这通过使用气缸盖衬垫实现.

The cast production technology and its control means of Cumins 6 BT cylinder head production are described.───叙述了康明斯6BT气缸盖铸造生产工艺及控制手段.

The basic casting method - design principle of cylinder head was introduced.───介绍灰铸铁缸盖铸造工艺的基本设计原则.

The conclusions are of benefit to the improvement of the diesel engine with integrated cylinder head.───得出的结论有益于对整体式气缸盖柴油机的改进设计.

There is no EGR passage in cylinder head.───有没有缸盖废气再循环通道。

A process of cylinder - head structure optimum is described in this paper.───介绍了气缸盖的结构优化过程.

Clean the exhaust manifold and cylinder head mating surfaces.───清洁排气歧管和汽缸头配合面.

The most common cylinder head types are the hemi, wedge, and semi - hemi.───最常见的气缸盖类型是半球形, 楔形和准半球形.

It is often located at the cylinder head near the radiator lapse, depending on the car make.───它通常是位于汽缸头靠近散热器的堕落，根据汽车制造。

The powder cylinder head good case of impurities. 3.───夺目把粉缸关好,以防杂质出去.

The features of cylinder block and cylinder head core assembly vertical casting process are introduced.───介绍了缸体、缸盖组芯立浇工艺的特点.

The cylinder head is heavily finned for strength.───汽缸头附有许多突片以增加强度.

Remove control cables from cylinder head cover clip.───从汽缸头盖扣夹上移去控制拉索.

The main defect of type YC 4112 Q cylinder head is blowhole.───气孔为YC4112Q气缸盖的主要缺陷.

The cylinder head is attached to the block with high - tensile steel studs.───气缸盖与气缸体用高强度的钢螺栓缚连结.

A new lateral casting process was introduced to produce YC 6 M cylinder head.───介绍了生产YC6M缸盖的侧浇铸造新工艺.

The cylinder head is heavily finned for strength.

Remove control cables from cylinder head cover clip.

The cylinder head gasket is made of solid steel.

Place the engine cylinder head over the dowels.

The powder cylinder head good case of impurities. 3.

Clean the exhaust manifold and cylinder head mating surfaces.

The engine block and alloy cylinder head is shared with the 1.4-litre Energy engine so the bore is identical.

The cylinder head has been carefully machined to increase air-flow.

This is achieved by using cylinder head gasket.