[电] 涂膜厚度

morning sickness───孕妇晨吐；孕妇怀孕初期的反应

sweating sickness───流行性粟粒疹热；汗热病

falling sickness───n.癫痫；（家畜的）癫痫发作

film thickness───（油）[物化]膜厚度

motion sickness───[医]晕动病（指晕船、晕车、晕飞机）

sweating sicknesses───出汗病

morning sicknesses───孕妇晨吐；孕妇怀孕初期的反应

boating lakes───划船湖

boating trips───乘船旅行

On the viscosity on coating thickness has a great impact, on a low viscosity, overlay thin.───上光油的黏度对涂层厚度有着较大的影响, 上光油的黏度低, 涂布层薄.

At the same temperature, the dipping time is longer, the greater the coating thickness.───在同一温度下，浸镀时间越长，镀层越厚。

Spraying equipment along with roller axial movement speed determines the roller surface coating thickness.───喷涂装置沿辊筒轴向移动的速度决定了辊筒表面获得的涂布厚度.

Coating thickness measurement control depends on the speed of the gap and roller.───涂层厚度的控制就取决于计量辊的间隙和辊筒的转速等因素.

Results show that thermal fatigue behavior is associated with circle temperature and coating thickness.───结果表明,复合涂层的热疲劳行为与热循环上限温度、涂层厚度有关.

Wet film thickness gauges may be used during coating to ensure correct coating thickness.───在涂敷时应采用湿膜测厚仪以确定准确的涂层厚度。

The influence of the coating thickness on the waveform is analyzed.───该方法为透明薄膜/基底系统的定量检测和无损评价提供了理论依据.

Books and periodicals on the cohesion and effectiveness of resin content, gummed coating thickness and grooving.───书刊的黏结效果与上胶量 、 背胶的涂布厚度及开槽大小有关.

lead fatigue strength is decreased linearly with the increase in nickel coating thickness.───镍层的引线随厚度的增加，抗疲劳强度呈直线下降。

Some poor quality aluminum plates to hide version based on the photoptic rubber coating thickness.───有些劣质版材为了包藏铝版底基上的砂纲,不兵感平胶膜层的厚度增不小.

The back of the coating thickness according to need.───不面后涂层的厚度可根据需给.

The mathematics model that showed photoresist spin coating thickness evolvement on spherical surface was put forward.───提出了球面旋涂微米级厚度光刻胶膜层薄化率公式及径向位置演变公式,并得到了膜厚分布的演变公式.

The influence of the coating thickness on the waveform is analyzed.

The mathematics model that showed photoresist spin coating thickness evolvement on spherical surface was put forward.

The back of the coating thickness according to need.

Surface layer numbers coating thickness, surfacecoating and substrate Composition test respectively etc.

Coating thickness measurement control depends on the speed of the gap and roller.

The effects of current density, bath temperature and coating thickness on the solderability and wetting balance of Pd coating electroplated on phosphor-bronze were studied.

On the viscosity on coating thickness has a great impact, on a low viscosity, overlay thin.

Measurement of coating thickness in the proof-test of IC packages and metal cases using X-Ray Fluorescence (XRF) spectrometry is described.

Key points in screen stenciling are advanced, including coating thickness, developing time and after treatment, matters needing attention in practice are put forward.