热耗; 耗热率; 加热速度; 加热速率

[热]升温速率；[热]加热速度；热耗率

floating rate───浮动利率

headline rate───税率；利率

starting rate───起动率

heating pad───电热垫；取暖电毯

heating pads───电热垫；取暖电毯

lending rate───贷款利率；[金融]放款利率

selling rate───[金融]卖出汇率；卖价

floating rates───浮动利率

headline rates───税率；利率

Some features of heating rate and cooling rate in different areas were investigated and analyzed.───分析研究了不同地区的大气辐射加热和冷却的一些特点.

In additional , influence of heating rate and particle diameter on combusting process is studied.───研究了升温速率、粒径对燃烧过程的影响,并计算出废轮胎燃烧动力学参数, 获得其燃烧反应机理.

Higher heating rate results in smaller grain size.───高的升温速率可获得较小的晶粒。

When the heating rate increases, all pyrolysis characteristic temperatures of King grass rise.───随着温升速率的上升，王草各热解特征温度都有所升高。

The effects of heating rate and temperature on the pyrolysis behaviors of EMAL are investigated.───了升温速率和热解温度对毛竹emal热失重行为的影响。

The influences of heating rate and soaking time on piezoelectric and dielectric properties were also studied.

The parameters of heating rate, energy, current waveform and time should be controlled precisely in order to insure the quality of minisize piece spot welding.

Effects of coal rank, coal maceral, temperature, heating rate, coal particle size, residence time, atmosphere, and pressure on the phenols production in coal conversion were discussed in this paper.

With the rise of heating rate, the maximum release rate of volatile and combustion rate of char, the burnout temperature and the combustible parameter increased, but the ignition temperature...

With the rising of heating rate the reaction rate increases, while volatiles conversion rate decreases.

In this paper, the heating temperature, thd heating rate, the holding temperature time and the cooling rate and so on were studied, and the direction to formulate technology parameters...

Explanation was given on improvement effect of heating rate to caking property from essence of chemical reaction using pyrolysis kinetics.

Annealing with the heating rate IV and V, the SPCC has small equated grains and lower nm, rm value, so it can only be used as a CQ level sheet steel.

With the rise of heating rate, the maximum decompose rate and its corresponding temperatures of biomass increases, but the final agravic quotient decreases.